Pelltech PV50c, Руководство пользователя

Страница: 15 / 40

DK9802C2 PV50c user manual ENG Vers: C2 page15/38
6 Installation of the burner to the boiler
Following tools are needed in order to install the burner:

Spanner no. 13

Spanner no. 10

Cross-head screwdriver

4 mm hex wrench
1
1
4
3
2
8
7
6
5
1. Remove burning chamber from the burner
housing by loosening burning chamber
bracket bolts (1). There is no need to
remove brackets or bolts completely.
2. Remove burning chamber by pulling and
slightly rotating it. At the same time motor
of grate lever and its power screw are
releasing from fast joint.
There is no need to remove grates when
connecting PV50c burner with its burning
chamber. Grates and grate lever may stay on
their places. They are connected to burners
housing via fast joint. If there is need to remove
grates anyway, e.g. for cleaning firstly remove
the upper grate (2) by lifting it up and then
lower grate (3) by releasing it from power
screw’s motor rod(4) Figure 9.
3. Fixate the flange (5) with bolts the door of
the boiler (6). Make sure that the opening of
the flange and the opening of the boiler door
are aligned.
4. Fixate the burning chamber (7). For that
place a ceramic seal (8) on the tube of the
burning chamber and pull tube through the
door in a way that chamber leans on the door
of the boiler. Fixate the burning chamber with
two hex grub screws to the flange Figure 10.
5. Connect the housing of the burner to the
burning chamber like it was done before
disassembling in step 1.
Figure 8 Brackets to move
Figure 9 Removing grates
Figure 10 Fixating elements