pela tools 506799, Руководство пользователя

Страница: 27 / 36

Security and troubleshooting
• If the machine for some reason runs badly,
stop immediately by pressing the ”stop” button.
The wheel stops right away.
• Press the ”start” button without the protective
hood down, the machine does not start and the
display shows Err-5.
• If the main shaft does not rotate, and the
display shows Err-1, check the motor,
motherboard and cable connections.
• If the main shaft rotates and the display shows
Err-1, check sensors, motherboard and cable
connections.
• If the machine does not stop after the
balancing is finished check the braking
resistance, the power supply, motherboard and
cable connections.
• If the display only shows dashes when you turn
on the power switch, a self-calibration may
need to be performed, an adjustment of
sensors or possible replacement of sensors.
• If the display shows something abnormal when
the machine is switched off, turn off the power
and count to 10 - switch on the power again - if
is not normal after that please contact us.
Maintenance & care
• Make sure that the machine always is clean.
• Before maintenance, always start by pulling out
the plug.
• Check the belt tension: pull out the plug and
remove the hood. The strap must be able to be
pushed approx. 4 mm downwards in the
middle.
• Adjust by loosening the engine mounting
screws and adjusting the engine position -
check that the belt does not come loose
laterally.
• Check that electrical parts are not damaged.
• Check that the screw on the balance shaft is
not loose, use an Allen key if necessary to
tighten it.
• If the display does not light up, check the power
indicator light. If not, there is a problem with
the power supply. If it flashes, please check the
power supply in the balancer, computer and
cable connections.
• Precision problems are not usually caused by
the balancing machine. This is often due to
incorrect wheel installation or incorrect balance
weight, or incorrect weight on the
self-calibration weight. Please save the original
100 gram counterweight in a safe place as it is
necessary for self-calibration.
• Instability and poor repeatability of data are not
usually caused by the balancing machine. This
is usually due to incorrect wheel installation,
or that the machine is not properly anchored.
Check the machine’s anchor bolts. If the
machine is not connected to a grounded
electrical outlet these problems can
sometimes occur.