Installation and Operating Manual
Page 7
INSTALLATION
The drying cabinet is only designed for
operation indoors in a dry environment at a
temperature above freezing point.
The drying cabinet should not be installed in
a location where high pressure water is used
for cleaning.
LEVELLING
The drying cabinet should stand level on a
flat
surface
, resting on all four feet.
FIXING TO WALL
Secure the cabinet to the wall using the screws, washers
and plastic plugs provided in the assembly kit.
1.
Open the door and drill two 8 mm holes into the
wall through the two pre
-
drilled holes in the rear
panel of the cabinet. Ensure any hidden water
pipes or cables etc. are avoided.
2.
Insert the wall plugs and, with the spacers and
washers provided, screw the cabinet back to the
wall.
WARNING !
The drying cabinet should not be used without being
screwed to a wall due to the risk of it tipping forwards.
LOCATION AND FIXING
The drying cabinet should not be installed in a
location where any doorways or safety exits are
blocked when the door is open and the hanging
rails extended.
Ensure that the cabinet is fully pushed back to the wall
behind. If there are obstacles behind the unit e.g. service or
drainage pipes, spacer battens or off
-
set fixing brackets (see
image below) should be used to prevent the cabinet from
tipping forwards.
An offset fixing bracket is
available as an optional
spare part.
Part no. 670001484
(A pair of 50mm off
-
set
brackets with 4 screws to
secure to the cabinet).
