Installation and Operating Manual
Page 16
TROUBLESHOOTING
Problem
What you can do
The fan does not operate and
the cabinet is not heating up:
Check that the cabinet is connected to the power supply and that
the fuses are intact. When the cabinet is switched on, there should
be a time displayed from the previous drying programme and two
LEDs should be lit.
Resonance or vibration occurs
when the fan is running:
Check that the cabinet is level in both planes and is securely fixed
to the wall. If the problem persists, try adjusting the feet ensuring
they are all in contact with the floor. See page 7 of this manual for
instructions.
The door switch is not working:
Figure shows an even gap
between the control panel
and the top of the door.
To test the switch, select a drying programme, close the door, and
press
START/STOP
. If the display shows
-
P
-
,
open the door and
manually press the switch with your finger
-
the switch is found
directly beneath the control panel, to the left
-
hand side. If the drying
programme resumes, the door switch is functioning properly.
Check that an even gap exists between the control panel and the
top of the door. If they are not aligned properly, this may not
activate the switch. To rectify, ensure the cabinet is level and adjust
the feet and/ or door if necessary (see page 5 of this manual).
Drying is taking a long time /
does not dry:
1.
Check that the correct programme has been selected for the type
of laundry.
2.
Check that the laundry is not too wet (poorly spun).
3.
Check that too much laundry has not been loaded into the
cabinet.
4.
Adjust the parameters according to the section “Parameters to
Adjust” (Page 14)
Error Codes:
If a warning or error code is shown, try and reset the controller (see
page 15).
·
Er 1
-
Regulator sensor. There is an error in the sensor at the
element. The error is either a discontinuity or short
-
circuit in the
sensor. Reset by disconnecting the power supply.
·
Er 2
-
Outlet sensor. Error in the sensor in the outlet duct. This
error is the same as Error 1. Reset by disconnecting the power
supply.
·
Er 3
-
MAX hours. The programme has not changed temperature
but has been turned off because the electronics has not received
a signal from the outlet sensor that the laundry is dry. Reset by
pressing the
START/STOP
button for 5 seconds.
In the event of further or persistent problems, please contact your dealer.
