Installation and Operating Manual
Page 15
CARE
SERVICE AND REPLACEMENTS PARTS
If the connecting cable is damaged for any
reason, it must be replaced immediately.
All genuine parts can be obtained from the drying
cabinet dealer.
NOTE.
A replacement lead may only be
installed
by
the
manufacturer,
the
manufacturer’s service agent, or another
authorised electrician.
BREAKDOWNS
WARNING!
Isolate the electrical supply and
remove the power plug before withdrawing
the service control unit.
The service module can be removed from the
cabinet to enable any repairs or maintenance
work to be carried out.
You
MUST first disconnect the cabinet from
the power source
, then open the door before
removing the five screws underneath the control
panel. Carefully pull the service module out.
Overheat Cut
-
Out:
The cabinet is equipped with an overheat cut
-
out. This trips when the temperature in the fan unit exceeds
120
°C.
·
When the over
-
heat cut out has tripped, the
display and LEDs flash. The overheat cut
-
out can be reset by turning off the power
supply with the switch inside the roof of the
cabinet (see illustration).
·
It is necessary to wait 10 to 15 minutes for
the temperature to fall, and for the overheat
cut
-
out to reclose. The power supply can
then be turned back on using the same
switch.
1. Service module
2. 5 x Torx screws
