12 of 13
ISSUED: 04-24-08 SHEET #: 055-9256-9 11-21-11
To adjust yaw (swivel):
Loosen screw on projector mount assembly (
A
) indicated below until projector mount can
be rotated. Rotate mount to desired position and retighten screw.
To adjust pitch (forward and backward tilt)
: Using 4 mm security t-wrench (
L
) (security adjustment models) or a
phillips screwdriver (non-security adjustment models), loosen two screws for pitch adjustment on projector mount
assembly (
A
) indicated below. Tilt mount to desired position and retighten screws.
To adjust roll (side to side tilt)
: Using 4 mm security t-wrench (
L
) (security adjustment models) or a phillips
screwdriver (non-security adjustment models), loosen two screws for roll adjustment on projector mount assembly
(
A
) indicated below. Tilt mount to desired position and retighten screws.
Projector Alignment
20° (±10°) SWIVEL
SWIVEL A D J U S T M E N T
TOP VIEW
10
MOUNT ASSEMBLY
NOT SHOWN FOR
CLARITY
IMPORTANT
: For security installations, insert one #10-32 x 1/4" socket pin screw (
E
) through projector mount
assembly (
A
) and into connection block as shown. Tighten screw with 4mm security t-wrench (
L
).
9
CONNECTION BLOCK
A
E
A
SCREWS FOR PITCH
ADJUSTMENT
SCREW FOR SWIVEL STOP
SCREWS FOR ROLL
ADJUSTMENT
• Do not loosen adjustment screws to the point they become disengaged from the mount. Weight of the projector
should be supported in case of accidental disengagement.
WARNING
