10 of 13
ISSUED: 04-24-08 SHEET #: 055-9256-9 11-21-11
Wall installation:
Insert horizontal mounting plate (
FF
) into inner channel (
CC
) as shown in fi gure 5.3. Secure
horizontal mounting plate to inner channel using four socket pin screws (
JJ
) as shown in fi gure 5.4.
5
fi g. 5.3
FF
CC
ARROW INDICATES
FRONT OF MOUNT
fi g. 5.4
FF
JJ
CC
NOTE
: The projector you are installing may differ in appearance from the sample illustrated below.
Place projector upside down. Locate adapter plate (
B
) with notch facing forward as close to projector center of
gravity as possible without covering any mounting holes. Loosen channels with 4 mm security allen wrench (
I
),
and
if there are only three mounting holes remove fourth channel
. Using one channel for each mounting
hole, position feet of channels over mounting holes as shown below.
IMPORTANT:
: If projector does not have
at least three mounting holes, do not use this adapter plate.
NOTE
: Some projectors have feet which can be removed and the corresponding threaded insert can be used
for a mounting hole.
NOTE
: Once channels are in position retighten fasteners.
*Notch indicates front of projector.
6
Attaching Adapter Plate to Projector
GENERIC PROJECTOR
*
MOUNTING HOLE
CHANNEL
FOOT OF CHANNEL
B