2 of 13
ISSUED: 04-24-08 SHEET #: 055-9256-9 11-21-11
NOTE:
Read entire instruction sheet before you start installation and assembly.
Tools Needed for Assembly
•
stud fi nder ("edge to edge" stud fi nder is recommended)
•
drill
•
phillips screw driver
•
5/16" bit for concrete and cinder block wall
•
open end wrench
•
5/32" bit for wood stud or joist
•
level
•
8 mm open end wrench
Table of Contents
Parts List............................................................................................................................................................................. 3-4
Installing Outer Channel to Ceiling Plate ...............................................................................................................................5
Installation to Wood Joist Ceiling or Wood Stud Wall .............................................................................................................6
Installation to Solid Concrete Ceiling or Concrete/Cinder Block Walls ...................................................................................7
Installing Inner Channel and Routing Cables .........................................................................................................................8
Installing Projector Mount ................................................................................................................................................. 9-10
Attaching Adapter Plate to Projector................................................................................................................................10-11
Projector Alignment ............................................................................................................................................................. 12
Adjusting Mount Extension .................................................................................................................................................. 13
Installing Cable Covers........................................................................................................................................................ 13
• Do not begin to install your Peerless product until you have read and understood the instructions and warnings
contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, for US
customers please call Peerless customer care at 1-800-865-2112, for all international customers, please contact
your local distributor.
• This product should only be installed by someone of good mechanical aptitude, has experience with basic building
construction, and fully understands these instructions.
• Make sure that the supporting surface will safely support the combined load of the equipment and all attached
hardware and components.
• Never exceed the Maximum Load Capacity. See page one.
• If mounting to wood ceiling/wall studs, make sure that mounting screws are anchored into the center of the studs.
Use of an "edge to edge" stud fi nder is highly recommended.
• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Tighten screws fi rmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding
power.
• This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal
injury.
• This product was designed to be installed on the following wall construction only;
WALL CONSTRUCTION
HARDWARE REQUIRED
• Wood Stud
Included
• Wood Beam
Included
• Solid Concrete
Included
• Cinder Block
Included
• Brick
Contact Customer Service (not evaluated by UL)
• Other or unsure?
Contact Customer Service (not evaluated by UL)
WARNING
