background image

WARNING

Please carefully inspect the product before assembling. If you notice any apparent damage, call your 
carrier claims agent and do not continue the installation until it has been reviewed. Please watch for 
pinch points. Do not put your fingers between moveable parts. Do not tamper with or disassemble any 
spring loaded parts. Before installing, make sure that the supporting surface will support five times the 
combined load of the solution and the hardware. Never exceed the maximum load capacity. Please also 
layout all components to ensure that you have all of the required parts before proceeding (see BOM list 
on following page). Use of this product for anything other than its specified use may result in failure or 
personal injury. This product is intended for indoor use only. We recommend using a qualified trades 
person for installation. Use an assistant or lifting equipment to lift and position products.

For support, please call: +44 (0)1865 767676 or email: [email protected]

Revised 15/12/20

01865 767676

[email protected]

www.unicol.com

*Please check model specific details before installing*

TVV1 / TVL1 / TVT1 / TVB1

Screen Size:

 15-40”

Guide Max. Weight:

 15kg

Содержание TVV1

Страница 1: ... maximum load capacity Please also layout all components to ensure that you have all of the required parts before proceeding see BOM list on following page Use of this product for anything other than its specified use may result in failure or personal injury This product is intended for indoor use only We recommend using a qualified trades person for installation Use an assistant or lifting equipm...

Страница 2: ... com 2 Revised 15 12 20 COMPONENTS INSTALLERS REQUIRED 1 2 DESCRIPTION QTY 1 1000mm Column 1 2 Single Column VESA Mount 1 3 Tevella Base 1 4 Column Support Ring 1 5 Alternative Bases TOOLS REQUIRED 1 3 16th Allen Key 2 5mm Allen Key 1 2 3 4 5 ...

Страница 3: ...hlighted above STEP 2 Place the column support ring over the crocodile lug with the straight edge facing the rear of the base as shown above Thread the cabling through the column and place the column with holes located approx 75mm from the bottom over the crocodile lugs on the base STEP 3 Once placed tighten the grub screw to secure into place STEP 4 Locate the mounting holes on the back of your s...

Страница 4: ...the screws STEP 1 Position floor plate and mark through the screw holes arrows above where it will be positioned Before you screw through ensure any cables that are going underneath the plate are threaded through the column grips circled above Continue with Step 2 STEP 1 Before you begin make sure the base is stable and ensure the brakes are on on the front two castors Loosen the screws on the col...

Отзывы: