Peavey AQ 12, Руководство по эксплуатации, Страница: 7 / 20

Rear Panel
LEVEL (4)
Controls the gain or output level of the input signal from the input jack (6). It is used to directly set the system
output level for a given input signal.
SIG LED (5)
Shows when a signal is present at the input (6)
INPUT (6)
The line input is of the medium impedance balanced type. The jack is a combo female XLR and 1/4” TRS con-
nector.
Sensitivity of this input is 0.50 volts for full output, when the MIC/LINE switch (7) is in the LINE position
MIC/LINE switch (7)
Switches between LINE level gain (out position) and MIC level gain (in position). MIC position increases gain
20 dB to allow use of most dynamic microphones.
NOTE: Phantom power is not supplied on the INPUT (6) jack.
GRND LIFT switch (8)
Allows the input cable shield to be disconnected from the chassis ground to alleviate hum from ground loops
SPKR LINK LED and button (9)
LED illuminates blue when the Spkr Link button is pushed and the Bluetooth® link is established
BT PAIR LED and button (10)
LED illuminates blue when the BT Pair button is pushed and the speaker is paired with another Bluetooth® de-
vice.
ON-OFF SWITCH (3)
This rocker switch supplies AC power to the
AQ™112
when switched to the ON
position. The ON position is with the top side of the switch pushed “in” or nearly
flush with the rear panel.
TOP OF REAR PANEL - OPERATING CONTROLS, INPUTS & OUTPUTS
LEVEL (4)
Controls the gain or output level of the input signal from the input jack (6). It is
used to directly set the system output level for a given input signal.
SIG LED (5)
Shows when a signal is present at the input (6)
INPUT (6)
The line input is of the medium impedance balanced type. The jack is a combo
female XLR and 1/4" TRS connector.
Sensitivity of this input is 0.50 volts for full output, when the MIC/LINE switch (7)
is in the LINE position
MIC/LINE switch (7)
Switches between LINE level gain (out position) and MIC level gain (in position).
MIC position increases gain 20 dB to allow use of most dynamic microphones.
NOTE: Phantom power is not supplied on the INPUT (6) jack.
GRND LIFT switch (8)
Allows the input cable shield to be disconnected from the chassis ground to
alleviate hum from ground loops
AQ12