Peavey AQ 12, Руководство по эксплуатации, Страница: 14 / 20

Finally, realize that even though the AQ™12 is a powerful and high output unit, it does ultimately have limits, and
it may need additional powered units (or a subwoofer) to provide enough sound output or coverage. In this case,
try turning the mixer levels down a little to see if that clears things up. If, after checking all the things listed to
check and anything else you can think of to check safely, and the system still exhibits problems, carefully note all
conditions and check with your Peavey dealer for advice.
Care and Maintenance
Your AQ™12 is a sturdy and durable product and will provide years of reliable use if properly cared for. Use com-
mon sense and read the safety warnings to avoid hazardous operating conditions.
The unit must be disconnected from the AC power source before any work is done on it. Refer all servicing to
qualified service personnel.
Sunlight/Heat
Avoid prolonged exposure to direct sunlight, as this may cause the unit to overheat and thermally shut off.
Excessively hot operating conditions can also cause a thermal shutdown.
Do not store in extremely hot or cold conditions or extremely high humidity. Always allow unit to come to room
temperature before use.
Cleaning
Never clean the AQ™12 while plugged in or turned ON! When the unit has been fully disconnected from AC
power sources, use a dry cloth to remove soil or other dirt. Never use strong solvents on the AQ™12, as they
could damage the cabinet. Do not allow ANY fluids to drip inside the AQ™12.
Touchup
For an overall finish enhancement and protective coating, use gloves to apply a plastic finish protector, such as
Armor-All® protectant or a similar product, to the surface of the plastic cabinet only. Note that the cabinet will be
slippery after these treatments; rub them down vigorously with a dry, lint-free cloth to minimize this.
Check for Secure Hardware
After the first few weeks of use and periodically thereafter, check the hardware of the AQ™12 for tightness, in-
cluding the rear panel screws and the screws that hold the baffle and rear cabinet together.
The unit is subject to a great deal of vibration, and this could cause them to loosen with use.
Architectural and Engineering Specifications
The powered loudspeaker system shall have a frequency response from 68 Hz to 19 kHz. The peak SPL with
inaudible distortion shall reach 125 dB with music as a source, when measured at a distance of 1M and driven to
full output capacity. The system shall utilize a 12” heavy-duty woofer and a
Peavey® DX™14 1.4” titanium diaphragm dynamic compression driver. The nominal radiation pattern shall be
110° in the horizontal plane, and 80° in the vertical plane. Axis of the vertical main polar lobe is angled down 10
degrees, resulting in the angular pattern with respect to straight ahead being +30, -50 degrees.
The powered, bi-amplified loudspeaker system shall have an input channel consisting of a medium impedance
input connector consisting of one combo female XLR and 1/4” TRS phone jack on the rear panel. There shall
also be a means to connect to the speaker system via Bluetooth®, and for the speaker system to be paired with
another Bluetooth® capable speaker.
There shall be a Thru/Mix (output) connector consisting of a male XLR jack.
It can provide either a Thru signal or a Mixed signal via a push button selection.