PDi WaveStar 2000A, Инструкция по установке и эксплуатации

Страница: 62 / 107

WaveStar Static Transfer Switch 2000A 3-Pole
62
Ctrl Nr: PM375118-004
2. The Ethernet port must be connected to a network with a reachable time server supporting
SNTP.
3. You must have the IP address of the time server. The time server could be a dedicated time
server possibly with a GPS receiver, a local computer running time server software, or a time
server on the Internet. You should preferably use a local time server. All equipment related to
the STS should use the same time server if they have access.
Figure 25 TIME Screen
To have the STS use Simple Network Time Protocol (SNTP), follow these steps:
1. Press Time button at the bottom of the screen. The TIME screen displays (Figure 25).
2. Press the Server
button. Enter the time server’s IP address.
3. Press the Zone button. Enter the time zone offset from Coordinated Universal Time (UCT) (-4
is Eastern Daylight time).
4. Make sure the Use SNTP Server checkbox has a green check. Touch Use SNTP Server to
toggle between the green check (use SNTP Server) and red X (do not use SNTP Server).
5. Press Get to initialize time and verify that Time Synchronization is working.
6. Touch Set to confirm date/time.
7. Touch Save to save settings.
10.4 SNMP
The STS supports SNMP over its Ethernet connection. The STS sends a single trap, a summary alarm, if
any alarm condition is raised on the STS. Touch the
SNMP button on the Home Screen to display the
SNMP Screen (Figure 26). Touch MORE to display additional buttons if SNMP butto
n doesn’t show.
Toggle Use SNTP Server to
the green check mark.
Server : set IP address of time
server.
Zone : time zone displaced from
UCT.
Get: initialize time.
Set : confirm date/time.
Save save settings