Better Solutions Are Within Reach
TM
MODEL NUMBER:
PDI-P26/ P32/ P40 LCD
Document Number:
PD196-145R3
Quick Start Guide
Page 8 of 9
PDi Communication Systems, Inc. 40 Greenwood Lane Springboro, Ohio 45066 USA PH 1-800-628-9870 FX 937-743-5664
Minimum Volume
This sets the minimum volume level the TV can reach. For pillow speakers with an adjustment thumbwheel volume control, ALWAYS
set a minimum volume level for the TV. A minimum volume setting is usually not required for pillow speakers with dedicated Volume
Up and Down buttons.
NOTE: Setting this level to any value other than 0 guarantees that some level of sound will always be heard when
the TV is operating.
1.
In the Sound
menu, press
CH▲ or CH▼ to highlight Minimum
Volume
.
2.
Press
VOL◄ or VOL► to select the preferred minimum volume.
3.
Press the SETUP
button to return to the preceding menu.
Power on Volume
This sets the initial volume the TV starts at upon powering on. Once the TV is on, the volume can be set to any allowable level.
In Sound
menu, press
CH▲ or CH▼ to highlight Power on Volume.
1.
Press
VOL◄ or VOL► to select the preferred volume when the TV turns on.
NOTE
:
Setting the level to LAST causes the TV to remember the last volume level used by the TV prior to turning off.
2.
Press the SETUP button to return to the preceding menu.
Cloning
Cloning allows quick programming of a TV using a USB Flash Drive. First a specimen TV is hand-programmed using a programming
remote control (PD108-420) with channels, sound, and other settings. While the TV is “ON” a USB thumb drive is inserted into that
TV’s USB port, the specimen TV’s setup written to the thumb drive, and then the thumb drive is removed to program other
televisions. One thumb drive can be used to program an entire hospital of televisions.
Save Settings to USB
1. Turn the TV On.
2. Insert thumb drive.
3. Press
CH▼ to highlight Save Settings to USB.
4.
Press VOL► to enter the menu.
5. P
ress CH▲ to initiate Clone mode.
6. A status message indicates Successful Saving of TV information to
the USB.
7.
Remove the USB Disk from the TV.
