Better Solutions Are Within Reach
TM
MODEL NUMBER:
PDI-P26/ P32/ P40 LCD
Document Number:
PD196-145R3
Quick Start Guide
Page 4 of 9
PDi Communication Systems, Inc. 40 Greenwood Lane Springboro, Ohio 45066 USA PH 1-800-628-9870 FX 937-743-5664
Wall Mounting for PDI-P32LCD TV and PDI-P40LCD TV
The PDI-P32LCD and PDI-P40LCD TVs require a PD181-672 200mm to 100mm Adapter Plate
(Not supplied with TV)
, a PD181-596
LCD Mounting Bracket
(Not supplied with TV)
, and a PD181-674 HD Extended LCD Tilt Clevis
(Not supplied with TV)
to be mounted
to the wall.
1.
Refer to Figure 1.
For the PDI-P32LCD find a location on
the wall 10.5 inches below the ceiling to mount the HD
Extended LCD Tilt Clevis (wall mount). For the PDI-
P40LCD, the location will be 10 inches below the ceiling.
NOTE
: DO NOT locate AC, Across-Room
Wiring, and CATV Signal outlets below the
Wall Bracket’s location as it will cause
clearance issues and interfere with the TV’s
cabinet when mounted to the bracket.
2.
Position the HD Extended LCD Tilt Clevis and locate two
mounting holes. Place one of the supplied ¼” flat washers
(PDIFW25) and the ¼” lock washer (PDISLW25) on a ¼”
screw (not included) and insert it into the top mounting hole
of the clevis. Secure the clevis to the wall. Place the other
supplied ¼” flat washer on another ¼” screw and insert it in
the bottom mounting hole. Secure it to the wall and tighten
both screws.
3.
Refer to Figure 2
. Attach the LCD mount to adapter plate
using the four M4 screws (PDIPPHMSM4X76) and four #10
Internal Tooth Lock washers (PDIITLW10).
NOTE:
The side with the four hex sides will
go toward the back of the set.
4.
Position the mounting bracket and adapter plate on the LCD
TV cabinet. Attach with the four M6 screws
(PDIPPHMSM6X110) that are provided.
Mounting Connections
Mounting Pieces
Part #
Part
PD181-672
200mm to
100mm
Adapter Plate
(1)
PD181-596
LCD Mounting
Bracket (1)
PD181-674
HD Extended
LCD Tilt Clevis
(1)
Screws and Washers
PDIPPHMS103
238
10-32X3/8
PPHMS (2)
PDIITLW10
#10 Internal
Tooth Lock
Washer (6)
PDIPPHMSM4
X76
M4-.7X6mm
PPHMS (4)
PDIPPHMSM6
X110
M6-1X10mm
PPHMS (4)
PDIFW25
¼” flat washer
(2)
PDISLW25
¼” lock
washer (1)
Numbers in parenthesis represent
quantity
Figure 2
PD181-672: 200mm to
100mm Adapter Plate
PD181-596: LCD
Mounting Bracket
PD181-674: HD Extended
LCD Tilt Clevis
5.
Mate the mounting bracket to the clevis making sure
the resting pins are inserted in the two notches at the
front of the clevis. Secure with the two 10x32 screws
(PDIPPHMS103238) and the two remaining Internal
Tooth Lock washers.
6.
The TV’s tilt can be adjusted by loosening both Pilfer
Screws, adjusting tilt, and then tightening the screws.