Page
Fuze Part # 4532 - Patent Pending
May 2007
May 2007
Fuze Part # 4532 - Patent Pending
Page
Page
Fuze Part # 4532 - Patent Pending
May 2007
May 2007
Fuze Part # 4532 - Patent Pending
Page
b. Width
i. Undo the 4 fasteners (B in Figure 4)
ii. Insert one half of the stroller handle into a back cane, secure it with a
TXLFNUHOHDVHSLQ&LQ¿JXUH
iii. Insert the other half of the stroller handle into the other back cane
(previously set to the desired width) and fasten it with a quick release
pin. Slide the connecting tube until it lines up with 2 sets of holes on
each half of the handle.
iv. Replace and tighten the fasteners and push on the handle to make
sure it’s secure.
F. Quick Release Axles (Optional)
È
WARNING
È
If any adjustments (size or position) to the rear wheels have been made, the
anti-tippers must be adjusted to maintain the 1-1/2 to 2-inch clearance. If this
adjustment cannot be made with the anti-tippers currently installed, a differ-
HQWPRGHOPD\EHUHTXLUHG&RQVXOWDTXDOL¿HGWHFKQLFLDQIRUDVVLVWDQFH
È
WARNING
È
Make sure detent button and locking balls of the quick-release axles are fully
engaged BEFORE operating the wheelchair. The locking balls MUST be
protruding past the inside of the axle mounting plate for a positive lock. Keep
locking balls clean.
1. Installation
a. Push in the detent button of the quick-release axle and insert the quick-
release axle through the center bearings of the rear wheel.
b. Push in the button of the quick-release axle again and insert the axle
(with wheel) into the axle mounting plate on the side of the wheelchair
frame until the assembly locks in place.
c. If the locking balls of the quick-release axles are not protruding past
the inside of the axle mounting plate or there is too much movement
of the rear wheel assembly in a back and forth position, refer to
ADJUSTMENT section below.
d. Repeat STEPS a to c for other rear wheel assembly.
e. Adjust the wheel locks. Refer to WHEEL LOCKS SECTION of this
manual.
23
