Page
Fuze Part # 4532 - Patent Pending
May 2007
May 2007
Fuze Part # 4532 - Patent Pending
Page
Page
Fuze Part # 4532 - Patent Pending
May 2007
May 2007
Fuze Part # 4532 - Patent Pending
Page
5. SET-UP AND ADJUSTMENT
È
WARNING
È
After ANY adjustments, repair or service and BEFORE use, make sure all
attachment hardware is tightened securely; otherwise, injury or damage may
result.
A. Footrests – Swing-away (70° and 90°)
1. Installation
a. Turn the footrest to the side (open footplate is perpendicular to
wheelchair).
b. Insert footrest mounting pin into mounting tube.
c. Rotate the footrest towards the inside of the wheelchair until it locks into
place. The footplate will be on the inside of the wheelchair when locked
in place.
d. Repeat this procedure for other footrest assembly.
2. Removal
a. To release the footrest, push the footrest release lever.
b. Rotate footrest outward and lift.
3. Adjusting
NOTE:
Release the footrest locking mechanism and lift the footrest
mounting pins out of its mounting tube.
NOTE:
Make sure to note the position of the washers before disassembly.
a. Remove impact guards and/or calf strap, if so equipped.
Remove the
hex screw and coved washer and position the footrest assembly to a
determined height.
b. Line up the mounting hole in the footrest frame, reinsert the hex screw
and coved washer; hand-tighten.
c. Securely tighten the hex screw and coved washer.
d. Repeat this procedure for the other footrest.
e. Replace impact guards and/or calf strap, if so equipped.
18
