SeeGull
®
IB
flex
®
Reference Manual
PCTEL, Inc.
Page 22 of 42
Rev T
The subnet mask number must be identical
for both the scanner and connected PC.
Example:
PC:
IP Address: XXX.YYY.ZZZ.
2
Subnet Mask: 255.255.255.0
Scanner:
IP Address: XXX.YYY.ZZZ.
100
Subnet Mask: 255.255.255.0
IP Address Note:
XXX.YYY.ZZZ is the network identification
and is identical for the PC and scanner.
The bold numbers are the host identification
and cannot be identical.
Default Network Configuration:
The IB
flex
comes with the following default
network configuration:
DHCP: Disabled
IP Address: 192.168.2.100
Subnet mask: 255.255.255.0
Default Gateway: None
Note: IBflex scanners purchased before
release v1.3 require a firmware upgrade
to enable the free Ethernet option.
Updating firmware will not autofill the
default network configuration. The user
must manually enter desired
configuration using SeeGull Assistant.
Ethernet Using Static IP Address:
Using this method, an IP address and
Subnet mask are entered in to the PC
manually using numbers assigned by your
IT Department. A corresponding IP address
and identical Subnet mask are then
assigned to the scanner using SeeGull
Assistant.
Set Up PC
Repeat steps 1-6.
8. Select Use the following IP address.
Figure 18 - IP Address and Subnet Mask
9. The default network configuration of
IB
flex
may be used for the PC’s IP
address and Subnet mask. It is
recommended to confirm with your
IT department. Enter numbers and
press OK.
Set Up Scanner:
After the IP address and Subnet mask are
confirmed for the PC, the scanner must be
assigned a corresponding IP address and
identical Subnet mask using SeeGull
Assistant. Please refer to the SeeGull
Assistant User Guide for more information.
Note: Consult Your IT Department to
Assign IP Address and Subnet mask for
the Scanner.
