IDE Primary/Secondary Master/Slave UDMA (Auto)
Each IDE channel supports a master device and a slave device.
This mainboard supports UltraDMA technology, which provides
faster access to IDE devices.
If you install a device that supports UltraDMA, change the
appropriate item on this list to Auto. You may have to install the
UltraDMA driver supplied with this mainboard in order to use an
UltraDMA device.
Press <Esc> to return to the Integrated Peripherals screen.
OnChip PCI Device
This item has several sub-items:
VIA-3Q58 OnChip AC97 Audio (Auto)
Enables and disables the onboard audio chip. Disable this item if
you are going to install a PCI audio add-in card.
Press <Esc> to return to the Integrated Peripherals screen.
Super IO Device
This item has several sub-items:
Onboard FDC Controller (Enabled)
This option enables the onboard floppy disk drive controller.
Onboard Serial Port 1 (3F8/IRQ4)
This option is used to assign the I/O address and interrupt request
(IRQ) for the onboard serial port 1 (COM1).
Onboard Parallel Port (378/IRQ7)
This option is used to assign the I/O address and interrupt request
(IRQ) for the onboard parallel port.
Parallel Port Mode (ECP)
Enables you to set the data transfer protocol for your parallel port.
There are four options: SPP (Standard Parallel Port), EPP
(Enhanced Parallel Port), ECP (Extended Capabilities Port) and
ECP+EPP.
SPP allows data output only. Extended Capabilities Port (ECP) and
Enhanced Parallel Port (EPP) are bi-directional modes, allowing both
data input and output. ECP and EPP modes are only supported with
EPP- and ECP-aware peripherals.
32
