Standby Time Out
(Minute)
This sets the timeout for standby mode in
minutes. If the time selected passes without any
system activity, the computer will enter the
power-saving standby mode.
Suspend Time Out
(Minute)
This sets the timeout for suspend mode in
minutes. If the time selected passes without any
system activity, the computer will enter the
power-saving suspend mode.
FDC/LPT/COM
Ports
If you set this item to Monitor, any activity on
the floppy disk drive(s)/the parallel port/the
serial port can resume the system from a power
saving mode.
Ring On Power On
Your system can enter a software power down.
If you enable this item, the system can
automatically resume if there is an incoming call
on the built-in Fax/Modem.
Lan Card Power
On
Your system can enter a software power down.
If you enable this item, the system can
automatically resume if there is traffic on the
network adapter.
Keyboard Power
On
Your system can enter a software power down.
If you enable this item, you can resume the
system by pressing hot keys on the keyboard.
You must enable the jumper for Keyboard
Power On.
Stroke Keys
Selected
If you have enabled the Keyboard Power On,
use this item to select the hot keys to power on
the system.
RTC Alarm Power
On
Your system can enter a software power down.
If you enable this item, the system can
automatically resume at a fixed time on the
system’s RTC (realtime clock). Use the items
below to set the date and time of the wake-up
alarm.
PCI / Plug and Play Setup Page
This page sets some of the parameters for devices installed on the
system PCI bus, and devices that use the system plug and play
capability.
