Paul thermos 300 DC, Руководство по эксплуатации

Страница: 67 / 72

Status 08.06.09
We reserve the right to make
changes favouring technical
progress
.
Technical data
Heat recovery device
thermos 200 DC / 300 DC
© Paul Wärmerückgewinnung GmbH • August-Horch-Straße 7 • 08141 Reinsdorf • Deutschland
Tel: +49(0)375-303505-0 • Fax: +49(0)375-303505-55 • E-Mail: info@paul-lueftung.de • Internet: www.paul-lueftung.de
Equipment design:
MVHR components:
Components
suitable for
Passive
House
Dr. Wolfgang Feist
certificate applies to thermos 200 DC
Heat exchanger box: Material: HX plastic
Ventilation fans: EC radial fans with integrated electronics
Filters: Filter class: G4 (supply/extract air)
Option: pollen filter F8 (supply air)
Housing: EPP (foam)
Summer mode (bypass): motorised summer bypass valve, bypass shut-off insert with safety function in winter
operation
Duct connections: 160 mm dia. (socket size)
Elektrical connection: single-phase 230V, 50Hz
three-phase 3 x 230V, 50 Hz, with frost protection and back-up duct heater options
Central control unit:
LxWxD (mm): 340x300x80, or 340x300x140 with frost protection and back-up duct
heater options
Enclosure:
IP 44 (MVHR unit)
IP 20 (control unit)
Protection Class: I (acc. to EN 60335)
Weight: 35 kg
Notes:
•
Install the MVHR unit upright in a frost-free place, preferably > 10°C.
•
Never lay control cables for programmers and sensors in parallel to 230/400 VAC
cables (minimum distance of 20 cm) and never lay out cables in loop.
•
Install the control unit in a way to ensure there is no heat build-up and sufficient space
for service access.
•
Simultaneous fireplace operation is possible via an extra module for negative
pressure monitoring with a shut-down function for the ventilation unit and/or the
exhauster hood connected to the exhaust air duct.
Note:
The unit should be installed in a raised
position for best condensate discharge.
(100…200 mm depending on drain hose
length) – this increases the height of the
MVHR unit.