Paul CLIMOS F 200 Eco, Руководство по эксплуатации

Страница: 17 / 41

17
Fig 15: Mounting position inclined wall vertically
Air duct connection
When mounting the air ducts, the following points must be taken into account:
•
Mount the types of air ducts of the ventilation plant to the connection stubs according to the present
construction form
R (right - type A) or L (left - type B)
, see label air ducts next to the type plate.
Fig 16: Arrangement of air ducts depending on construction type – right (type A) or left (type B
)
•
Remove the caps of the air connection sockets
• Use air duct material with air resistance as low as possible, and connect the ventilation components air-tight
among each other
• The connection stubs of the device are made of EPP and have sleeve dimensions DN 125
•
The outdoor air and exhaust air ducts must be insulated in such a way that they are vapour-diffusion tight
•
In the event that a low point is unavoidable when installing the exhaust air duct from the device’s exhaust air
stub to the exhaust air outlet, a connection for condensate drain must be provided at that point
•
A straight pipe routing of the exhaust air from the device connection stub to the roof hood should be avoided,
since during defrosting of possible ice formations, they might fall onto the blades of the exhaust air fan and
cause damage to these blades
Fig 17: Arrangement drainage of the outdoor air duct and exhaust air duct
•
If a silencer is provided at the exhaust air stub, it must be guided upwards by means of a bend in order to
protect it against drenching caused by condensate returning from the exhaust air duct.
•
If the exhaust air is guided over the roof, this guidance must be equipped with a double-wall or insulated roof
lead-through. Thus, condensate formation between the roof boards is prevented.
A
B