10
- Remove the four Hopper Bolts using the
provided speed driver. The two bolts on
the Chamber Lid may be removed for
additional cleaning.
- Remove Pressure Plate by detaching
Pressure Plate Spring and sliding Pressure
Plate from inside of the Hopper. Pull
Retractable Meat Stop out of the hopper
until it stops. Remove feeder by loosening
bolt using the tool provided. Twist feeder
washer away from bolt and lift feeder from
the inside
- Remove Feed Tray by lifting it off the
Hopper, and Mold Plate Guard by
loosening the Guard Bolts, and unlatching
the push rod.
- Remove the Mold Plate by pulling the ring
pin and disengaging the Connecting Arm
from the T-Knob. This will allow the Mold
Plate to be removed from between the Guide
Rails and removed from the machine. The T-
Knob may also be un-screwed from the Back
Drive as an alternate means of disassembly.
Proper Disassembly for Cleaning
your Model PS21
Always Unplug Machine from its
Electrical Source Before Cleaning
-Loosen the two Hopper Bolts using the
disassembly tool provided. The two bolts on
the chamber lid may be loosened to be able to
remove the Chamber lid for additional
cleaning if necessary.
10
Feed Tray
Mold Plate Guard
Chamber
Lid
Guard Bolt
Hopper Bolts
Hopper
Main Shaft
Mold Plate
Back Drive
T-Knob
Spacer Plate
Connecting Arm
Retractable
Meat Stop
Ring Pin
Guard Bolt
Feeder
Washer
Pressure Plate
Spring
Pressure Plate
Chamber
Lid Bolts
Main Shaft
- Remove Hopper by sliding it toward the
on/off switch and lifting it off the Main
Shaft.
- After the Hopper is removed from the
machine, remove Spacer Plate from the top
of the Mold Plate. *Note--Occasionally the
Spacer Plate sticks to the bottom of the
Hopper. 3/4” Molds do not use a spacer
plate. Retaining Rod should be left in
storage position when using a 3/4” mold.
