12
Points of Daily Lubrication For
Your Model PS21:
The Following Parts should be lubricated daily
- Pressure Foot should be lifted up
and oiled. Hold the Acorn Nut and
lift up. Place a few drops of oil on
the Pressure Foot shaft.
Always Unplug Machine and use Food Approved Oil and Grease!
- Knock Out Shaft should be oiled
when the Knock Out Arm is in the
up position. The picture shown
displays the Arm in the up position.
- Tower Stem should be oiled when the
Feed Tray is removed as shown.
- Rod End Bearings should be oiled
with a few drops of oil. There are two
Rod End Bearings to be oiled. Do not
allow oil to drip onto the Conveyor
Belt.
- Main Shaft should be oiled when the
machine is disassembled as shown in this
picture. Be sure to oil the bottom of the shaft
by the Hopper Bushing.
- The inside of the machine can be lubricated
through the Rear Inspection Opening. By
spraying lithium grease here, you can
lubricate all internal moving components.
- The Grease Fitting on the side of the machine
by the On/Off switch should be greased once
every two weeks. 3 to 4 shots of grease are
recommended.
Tower Stem
Pressure
Foot Shaft
Rod End
Bearings
Main Shaft
Acorn Nut
Rear Inspection
Hole
Grease Fitting
located on this side
Conveyor Belt
Knock Out Shaft
Knock Out Arm
