Patton 1000, Руководство по началу работы, Страница: 33 / 181

SmartNode 2400 description
33
SmartNode 1000 and 2000 Series Getting Started Guide
1 • General Information
Rear panel
The SmartNode 2400 rear panel is depicted in figure 13 . There are four expansion slots for optional interface
cards, and four board-mounted sockets. There are four expansion slots for optional interface cards, and four
board-mounted sockets. The Link, and 100Mb/s LEDs indicate the status of the Ethernet ports. See appendix
B,
“Cabling” on page 165 for connection cable and appendix C, “Port pin-outs” on page 177 for pin-out data.
Figure 13. SmartNode 2400 rear panel
Expansion slots
The slots labeled SLOT 1, SLOT 2, SLOT 3 and SLOT 4 (see figure 13 ) accept different PMC interface cards to
integrate voice and data over IP networks (see “Interface cards descriptions” on page 35 for more information).
On-board ports
Three motherboard-mounted network interfaces are available for use, independent of those that may be
included with interface cards mounted in SLOT 1, SLOT 2, SLOT 3, or SLOT 4. The motherboard-mounted
ports are described in
table 11 (see appendix B, “Cabling” on page 165 for connection cable and appendix C,
“Port pin-outs” on page 177 for pin-out data).
Table 11. SmartNode 2400 port description
Port Description
ETH 0/1
(10/100BaseT)
Ethernet RJ-45 socket that connects the SmartNode with an Ethernet device, such as a
wide area transmission modem, Ethernet hub, or switch.
ETH 0/1 is a host port; it can
be connected with a straight-through wired cable to a hub, or a cross-over cable to a
host port. The
Link LED is lit when the port is connected correctly to an active Ethernet
device. The 100Mb/s LED is lit when the port is connected correctly to an active
100Base-T Ethernet device.
ETH 0/0
(10/100BaseT)
Ethernet RJ-45 socket that connects the SmartNode with an Ethernet device, such as a
wide area transmission modem, Ethernet hub, or switch.
ETH 0/0 is a host port; it can
be connected with a straight-through wired cable to a hub, or a cross-over cable to a
host port. The
Link LED is lit when the port is connected correctly to an active Ethernet
device. The 100Mb/s LED is lit when the port is connected correctly to an active
100Base-T Ethernet device.