Patton 1000, Руководство по началу работы

Страница: 136 / 181

9 • Interface card installation
SmartNode 1000 and 2000 Series Getting Started Guide
136
Installing interface cards
Installing interface cards
Figure 85 depicts an example of a card installation in SLOT 2 of a SmartNode 2000 Series device.
Figure 85. Example card installation in SLOT 2
To install interface cards, do the following:
1. Remove all cables, including mains power cord, Ethernet and telephone network interface cables.
2. Put on an ESD wrist wrap to prevent electrostatic discharge.
3. Use a Phillips screwdriver to remove the cover of the SmartNode. There are a total of nine screws on a
SmartNode 2300: three on each side, two on the top at the rear (connector-side) and one underneath at
the front (LED) side. The SmartNode 2400 has six screws, two on each side, one on the top at the rear
(connector-side) and one underneath at the front (LED) side.
4. Use a Phillips screwdriver to remove the blank filler panel from the expansion slot in which the interface
card is to be installed. Save the blank panel for future use.
5. Move the front panel of the interface card into the expansion slot opening of the SmartNode until it fits
correctly.
6. Press the interface card gently down until you feel its connector mate securely with the socket on the
motherboard. Take great care to ensure that the card fits correctly in the connector and is pressed fully
home.
7. Secure the interface card by replacing the 2 screws into the holes on the bottom of the SmartNode, using
the Phillips screwdriver (ee section “Card locating screws” on page 137).
8. Replace the cover and secure it to the side panels of the SmartNode chassis by the screws that you removed
in step 3.
9. Install the cables you removed in step 1, then connect the installed interface card cables.