Patton 1000, Руководство по началу работы

Страница: 26 / 181

1 • General Information
SmartNode 1000 and 2000 Series Getting Started Guide
26
SmartNode 1400 description
Figure 6. SmartNode 1400 front panel
See chapter 11, “Monitoring Status” on page 151 for more information on LED indications.
Rear panel
The SmartNode 1400 rear panel includes the following LEDs for at-a-glance status display (see figure 4 ):
• LINK LEDs that indicate the status of the Ethernet connections
• L2 LEDs that show the status of the BRI interfaces
The ports are described in table 6 (see appendix B, “Cabling” on page 165 for connection cable and appendix
C, “Port pin-outs” on page 177 for pin-out data).
Figure 7. SmartNode 1400 rear panel
Table 6. SmartNode 1400 port description
Port Description
ETH 0
10Base-T (Modem)
10Base-T Ethernet RJ-45 socket that connects the SmartNode with an Ethernet device
(usually a transmission modem, i.e. cable or DSL modem).
ETH 0 is a host port; depend-
ing on the pin out of the modem, it can be connected with a straight-through wired
cable or a cross-over cable. The
LINK LED to the left of the connector is lit when the port
is connected correctly to an active Ethernet device.