E1 PRI
50
SmartNode 4940 Getting Started Guide
C • Cabling
E1 PRI
The E1 PRI is usually connected to a PBX or switch—local exchange (LE). Type and pin outs of these devices
vary depending on the manufacturer. In most cases, a straight-through RJ-45 to RJ-45 can be used to connect
the PRI with a PBX. A cross-over cable is required to connect to an NT device, as illustrated in
figure 10
on
page 50.
Figure 10. Connecting an E1 PRI port to an NT1
Figure 11. E1 PRI port crossover cable
Hazardous network voltages are present in the PRI cables. If you detach the
cable, detach the end away from the SmartNode or interface card first to avoid
possible electric shock. Network hazardous voltages may be present on the
device in the area of the PRI port, regardless of when power is turned OFF.
To prevent damage to the system, make certain you connect the
PRI cable to the PRI port only and not to any other RJ-45 socket.
WARNING
WARNING
Cross-over cable
NT
RS
-23
2
Co
nso
le
ET
H 0
/1
Reset
0/0
0/1
0/2
0/3
T1
/E
1
RJ-48C, male
RX Ring
RX Tip
RX Shield
TX Ring
TX Tip
TX Shield
N/C
N/C
RJ-48C, male
RX Ring
RX Tip
RX Shield
TX Ring
TX Tip
TX Shield
N/C
N/C
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
*N/C = No connection*
Содержание SMARTNODE 4940
Страница 20: ...20 Chapter 2 Applications overview Chapter contents Introduction 21 Application Convert Legacy PBX to VoIP 21...
Страница 47: ...47 Appendix C Cabling Chapter contents Introduction 49 Console 49 Ethernet 50 E1 PRI 51 T1 PRI 52...
Страница 52: ...52 Appendix D Port pin outs Chapter contents Introduction 53 Console port 53 Ethernet 53 PRI port 54...
Страница 55: ...55 Appendix E SmartNode 4940 factory configuration Chapter contents Introduction 56...
