Introduction
28
SmartNode 4940 Getting Started Guide
4 • Initial configuration
Introduction
This chapter leads you through the basic steps to set up a new SmartNode and to download a configuration.
Setting up a new SmartNode consists of the following main steps:
Note
If you haven’t already installed the SmartNode, refer to chapter 3,
“SmartNode installation”
on page 22.
•
Configuring the desired IP address
•
Connecting the SmartNode to the network
•
Loading the configuration (optional)
Note
The SmartNode CD-ROM contains a collection of third party software
tools (including TFTP servers and Telnet utilities) to help you configure,
operate and monitor the SmartNode device.
Configuring the desired IP address
Factory-default IP settings
The factory default configuration for the Ethernet interface IP addresses and network masks are listed in
table 6
.
The Ethernet 0/0 port uses the DHCP client to automatically assign the IP address and network mask.
Connecting the SmartNode to the network
The SmartNode 4940 Series is equipped with an Auto-MDX Ethernet port, so you can use straight-through or
crossover cables for host or hub/switch connections (see
figure 6
).
Table 6. Factory default IP address and network mask configuration
IP Address
Network Mask
Ethernet 0 (ETH 0/0)
DHCP
DHCP
The interconnecting cables shall be acceptable for external use
and shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceability.
CAUTION
Содержание SMARTNODE 4940
Страница 20: ...20 Chapter 2 Applications overview Chapter contents Introduction 21 Application Convert Legacy PBX to VoIP 21...
Страница 47: ...47 Appendix C Cabling Chapter contents Introduction 49 Console 49 Ethernet 50 E1 PRI 51 T1 PRI 52...
Страница 52: ...52 Appendix D Port pin outs Chapter contents Introduction 53 Console port 53 Ethernet 53 PRI port 54...
Страница 55: ...55 Appendix E SmartNode 4940 factory configuration Chapter contents Introduction 56...
