End User License Agreement
59
SmartNode 4940 Getting Started Guide
F • End user license agreement
If the Program(s) are acquired by or on behalf of a unit or agency of the United States Government, the Gov-
ernment agrees that such Program(s) are
commercial computer software
or
computer software documentation
and
that, absent a written agreement to the contrary, the Government’s rights with respect to such Program(s) are
limited by the terms of this Agreement, pursuant to Federal Acquisition Regulations 12.212(a) and/or DEARS
227.7202-1(a) and/or sub-paragraphs (a) through (d) of the “Commercial Computer Software - Restricted
Rights” clause at 48 C.F.R. 52.227-19 of the Federal Acquisition Regulations as applicable.
6. Termination
A)
The End User may terminate this agreement by returning the Designated Equipment and destroying all
copies of the licensed Program(s).
B)
Patton Electronics Company may terminate this Agreement should End User violate any of the provi-
sions of section
“4. Grant of License”
on page 58.
C)
Upon termination for
A
or
B
above or the end of the Term, End User is required to destroy all copies of
the licensed Program(s)
7. Other licenses
The Program may be subject to licenses extended by third parties. Accordingly, Patton Electronics Company
licenses the Programs subject to the terms and conditions dictated by third parties. Third party software identi-
fied to the Programs includes:
•
A routing license is included at no charge.
•
MGCP capabilities will require the purchase of an additional license.
•
The LGPL (Lesser General Public License) open source license distributed to you pursuant to the LGPL
license terms (
http://www.gnu.org/licenses/lgpl.html).
•
RedBoot (Red Hat Embedded Debug and Bootstrap) embedded system debug/bootstrap environment
from Red Hat distributed to you pursuant to the eCos license terms (
http://ecos.sourceware.org/license-
overview.html
) and GNU General Public License (GPL) terms (
http://www.gnu.org/copyleft/gpl.html
).
Source code is available upon request.
Содержание SMARTNODE 4940
Страница 20: ...20 Chapter 2 Applications overview Chapter contents Introduction 21 Application Convert Legacy PBX to VoIP 21...
Страница 47: ...47 Appendix C Cabling Chapter contents Introduction 49 Console 49 Ethernet 50 E1 PRI 51 T1 PRI 52...
Страница 52: ...52 Appendix D Port pin outs Chapter contents Introduction 53 Console port 53 Ethernet 53 PRI port 54...
Страница 55: ...55 Appendix E SmartNode 4940 factory configuration Chapter contents Introduction 56...
