Patton electronics 1092RC, Руководство пользователя

Страница: 13 / 40

Switching the Power Supply On and Off
The power switch is located on the front panel. When plugged in
and switched on, a red front panel LED will glow. Since the Model
1000R16 is a "hot swappable" rack,
it is not necessary for any cards to
be installed before switching on the power supply
. The power supply
may be switched off at any time without harming the installed cards.
NOTE: Please refer to the Model 1000RP Series User Manual
AC
and DC Rack Mount Power Supplie s for fuse and power card
replacement information.
4.2 INSTALLING THE MODEL 1092RC SERIES INTO THE CHASSIS
The Model 1092RC Series is comprised of a front card and a rear
card. The two cards meet inside the rack chassis and plug into each
other by way of mating 50 pin card edge connectors. Use the following
steps as a guideline for installing each Model 1092RC Series into the
rack chassis:
1. Slide the rear card into the back of the chassis along the metal
rails provided.
2. Secure the rear card using the metal screws provided.
3. Slide the front card into the front of the chassis. It should
meet the rear card when it’s almost all the way into the
chassis.
4. Push the front card gently into the card-edge receptacle of the
rear card. It should “click” into place.
5. Secure the front card using the thumb screws.
4.3 WIRING THE MODEL 1092RC SERIES
Each of the rear interface cards compatible with the Model
1092RC Series has one terminal interface port and one 2-wire (twisted
pair) port. For specific interface pin-outs, refer to the diagrams in
Appendix C of this manual.
.
25
3.2.1 Configuring the Local 1092RC
To configure the local 1092RC, make a selection from the following
MAIN MENU. To configure the remote 1092 or 1092RC, type [$] (Shift-
4) and refer to
Section 3.2.2 .
MAIN MENU Option 1: Display Active Configuration
Select Option 1 to display the most recent configuration of the local
Model 1092RC (See below). The Model 1092RC uses the active
configuration for its operation. If you make changes to the
configuration, you must select MAIN MENU Option 8. This will update
the unit to the new active configuration.
3.2.2 MAIN MENU Option 2: Display Hardware Configuration
Select Option 2 to display the configuration of the hardware DIP-
switches. To use the Hardware Configuration for the Active
Configuration, select MAIN MENU Option 5. Then select “Use
Hardware DIP-Switches”. Finally, select MAIN MENU Option 8 to save.
12