32 | P a g e
PATON
®
PSI PRO 315 A 400 V DC MIG/MAG TIG/MMA
For ensuring the operability of the welding unit for a long-term service life, it is necessary to perform
the following procedures:
1.
Periodically, at specified time intervals, check that the safety requirements in operation of the
welding unit are fulfilled
(see "Safety instructions").
2.
At half-yearly intervals, purge the welding unit with dry compressed air.
3.
When working in environment with excessive dust content, manually clean the passages for
cooling air.
ATTENTION!
Purging the unit with compressed air at short distance can
result in damage of the electronic elements of the unit.
9. OPERATION WITH AN ELECTRIC GENERATOR
The welding unit can operate with power supply from an electric generator if the following conditions
are satisfied:
Electrode
diameter (mm)
Set welding current in
the MMA and TIG
welding processes (A)
Electrode wire diameter in the
MIG/MAG welding process
(mm)
Minimum power of
the generator
(kVA)
Ф
2
Not more than 80 А
Not more than
Ф
0,6 mm
2,9 kVA
Ф3
Not more than 120 А
Not more than
Ф
0,8 mm
4,5 kVA
Ф
4
Not more than 160 А
Not more than
Ф
1,0 mm
6,2 kVA
Ф
5
Not more than 220 А
Not more than
Ф
1,0 mm
9,0 kVA
Ф
6
niskotopliwa
Not more than 250 А
Not more than
Ф
1,2 mm
10,7 kVA
Ф
6
315 A
Not more than Ф1.4 mm
13,5 kVA
ATTENTION!
The output voltage of the electric generator must in the range
of 320 … 440 V.
The manufacturer suggest the use of a generator set with the
AVR system responsible for voltage stabilization.
10. STORAGE
The preserved and packed welding unit can be stored according to State Norm
for 5 years.
The
welding unit should be stored in a dry closed room at an ambient temperature not lower than 5ºC. In
the room, acid vapors and chemically active substances must not be present.
11. TRANSPORTATION
The packed welding unit can be transported by any means of transport, which ensure the integrity of
the unit and compliance of the unit with the shipping rules established for the specified transport
means.