Paton PSI 160 Standard, Руководство пользователя с гарантией

Страница: 11 / 38

10 | P a g e
PATON
®
PSI STANDARD SERIES DC MIG/MAG TIG/MMA
c) For welding with the "MIG/MAG" method with a solid wire - the polarization change wire
(14) is connected and the ground wire is connected to the "-" current socket.
B. (-) The bayonet connector socket for connecting:
a) The grounding cable (or the electrode cable in some cases when special electrodes are used
for welding) for the manual arc welding process
(MMA)
b) Only the argon gas torch for the argon arc welding process (TIG)
c) For welding with the "MIG/MAG" method with self-shield wire - the polarization change
wire is connected (14) and the ground wire is connected to the "+" current socket.
19. Push-button switch for switching on and off the welding unit;
20. Socket for supplying protective gas to the welding torch.
21. Fuse (overcurrent breaker)
2. SETTING THE WELDING UNIT INTO OPERATION
ATTENTION!
Read Section 16, "Safety instructions", before setting the
welding unit into operation.
2.1 PROPER USE
The welding unit is designed for manual covered-electrode arc welding (GMAW) , argon arc welding
(GTAW) , gas-shielded arc welding (GMAW) or flux-cored arc welding ( FCAW or FCA ) for a semi-
automatic or automatic arc welding process.
Any other use of the welding unit is considered as improper. The manufacturer of the welding unit is not
responsible for damages caused by any improper use of the unit. The use of the welding unit is proper if
all the requirements of this Operation Manual are satisfied.
ATTENTION!
Do not use the welding unit to unfreeze pipes.
2.2 REQUIREMENTS FOR INSTALLATION
The welding unit is protected against ingress of foreign particles more than 12.5 mm in size.
The welding unit is allowed for outdoor operation. The internal electrical and electronic elements of the
welding unit are protected against moisture but are not protected against atmospheric condensate drops.
ATTENTION!
After completing welding works in hot weather, or completing
intensive welding works in any weather, switch off the welding unit only after at
least 5 minutes of time required for the electronic elements of the unit to be
cooled.
ATTENTION!
When operating the welding unit in cold season, after the unit
was switched off and cooled, condensate can be formed inside of the unit, so
switch on the welding unit only 3 … 4 hours after the switching off!!!