PATON
Feeder
DC MIG/MAG
- 6 -
wire welding and the "negative" pole of the welding source when welding with flux-
cored wire.
2.5 CONNECTING THE POWER SOURCE CONTROL PLUG
To control switching the external welding power source on and off during semi-
automatic welding, use plug
17
with the following wiring diagram:
Only contacts 1 and 2 are used, which are closed at the right moments with a relay.
The maximum switching current is not more than 1.5A; the maximum switching
voltage is not more than 220V. At the moment when the source is supposed to be
running, the relay contacts are closed, when the source is supposed to be off
–
they
are open.
WARNING
!!! The wiring diagram in the power supply is
specific
to each application,
so it is not included in this manual for the wire feeder. Look for it in the power supply
manual.
The new generation of PATON power supply sources already includes all the
features, so the adaptation will be done with minimum effort. It is enough to check
the presence of the control connector on the rear panel of the source. If it is installed,
then it takes time only to fix the plug in this connector, if it is not present, then you
need to contact the service department to install it.
2.6 TURNING ON THE WIRE FEEDER
It is done with the power switch 13 on the rear panel of the unit.
2.7 SAFETY GAS SUPPLY
The hose from the safety gas cylinder is connected to connector
16
on the rear
panel of the unit.
WARNING!!!
A pressure reducer must already be pre-installed on the cylinder. The
optimum outlet pressure is individual for each case. If you are a beginner and have
not used
not used
Control
board
