PATON
Feeder
DC MIG/MAG
- 12 -
For Feeder-15-4 model:
-
Rollers for solid wire 0,6-0,8; 1,0-1,2
–
1 set;
-
Rollers for aluminum wire 0,8-1,0
–
1 set.
10. SAFETY INSTRUCTIONS
GENERAL PROVISIONS
The wire feeder is manufactured following technical standards and established
safety regulations. Nevertheless, if handled improperly, there is a risk of:
-
Injury to operating personnel or a third party;
-
Damage to the machine or material assets in the workplace;
-
Disruption of an efficient work process.
All persons involved in the commissioning, operating, maintenance and servicing of
the machine must:
-
Take appropriate certification;
-
Possess knowledge of welding;
-
Adhere strictly to these instructions.
Faults that could impair safety must be eliminated immediately.
USER OBLIGATIONS
The user is obliged to allow only those persons to work on the machine who:
- Are familiar with the basic safety instructions and have been trained in the use of
the welding equipment;
- Have read the "Safety instructions" section and the safety precautions in this
manual and confirm this with their signature.
PERSONAL PROTECTIVE EQUIPMENT
Observe the following rules for personal protection:
-
Wear sturdy shoes that retain their insulating properties, including in wet
conditions;
-
Protect your hands with insulating gloves;
-
Protect your eyes with a protective mask with a UV filter that meets safety
standards;
-
Use appropriate inflammable clothing.
HAZARD OF HARMFUL GASES AND VAPORS
-
Remove any smoke and harmful gases from the workspace using special means;
-
Ensure an adequate supply of fresh air;
-
Solvent vapors must not enter the radiation zone of the welding arc.
