15
Signal Tower LA6-POE Operation Manual
4. How to Operate
4.1. Operating Procedure
4.1.1. Controlling with Commands
①
Set up the LA6-POE network.
• Set the IP address for the network. (Refer to “4.3 Network Setup” on page 19)
②
Set up the LED unit colors and combinations.
• Use the data setup application to create the LED unit colors and combinations.
(Refer to the help section in the data setup application.)
• Use the Web Setup Screen to set up. (Refer to “4.4.2 WEB Setup” on page 22)
③
Load the Setup Data information into the LA6-POE.
• Use the Web Setup Screen to load the data. (Refer to “4.4.1 Loading Setup Data” on page 20)
④
Set up the control method.
• Use a command control system in the Main Unit to set up with. (Refer to “4.5 Main Unit Setup” on page 24)
⑤
Set up the receiving command protocols.
• When controlled by PNS or PHN Commands:
Set up for receiving commands. (Refer to “4.6 Command Configuration” on page 25)
• When being controlled by Modbus/TCP:
Set up for Modbus/TCP commands. (Refer to “4.7 Modbus/TCP Setup” on page 26)
• When controlling with HTTP command, no configuration is required.
⑥
Set up the contact inputs.
• Set up the operation sequence for when an input occurs at the contact input.
(Refer to “4.8 Contact Input Detection” on page 27)
* The contact inputs are: clear/mute/trigger/STOP
4.1.2. When Controlling with the Signal Line Inputs
①
Set up the LA6-POE network.
• Set the IP address for the network. (Refer to “4.3 Network Setup” on page 19)
②
Set up the LED unit colors and combinations.
• Use the data setup application to create the LED unit colors and combinations.
(Refer to the help section in the data setup application.)
• Use the Web Setup Screen to set up. (Refer to “4.4.2 WEB Setup” on page 22)
③
Load the Setup Data information into the LA6-POE.
• Use the Web Setup Screen to load the data. (Refer to “4.4.1 Loading Setup Data” on page 20)
④
Set up the control method.
• Use a command control system to set up with the signal lines. (Refer to “4.5 Main Unit Setup” on page 24)
⑤
Set up the receiving command protocols.
• When acquiring status conditions by PNS or PHN Commands:
Set up for receiving commands. (Refer to “4.6 Command Configuration” on page 25)
• When acquiring status conditions by Modbus/TCP:
Set up for Modbus/TCP commands. (Refer to “4.7 Modbus/TCP Setup” on page 26)
