GP-M230-BX-010A
2300 / IO 210 Manual
RD: June 2006
R.L. 10A
KH
CAUTION:
DO NOT INSTALL ANY GAS PIPING IN HEAT ZONES.
The maximum supply pressure must be limited to 14" w.c. (0.5 psi). If the line pressure is
above 14" w.c., then a separate pressure reducing regulator must be installed. The minimum
pressure at the inlet to the heater regulator must be equal to or greater than 6.0" w.c. for natural
gas and 11.0" w.c. for propane gas.
2.4 GAS PRESSURE
a) Properly install gas line as outlined in Section 2.3.
b) Mount heaters by using non-combustible mounting hardware as illustrated in Diagram 2.
Observe the minimum clearances as outlined in Sections 8.4 and suggested mounting dis-
tances in section 8.5
WARNING:
When using Wall Mounting Bracket JP-2300-MB, or Arm Mounting Bracket JP-
2300-MA, ensure the anchoring to the structure is of sufficient strength, quality
and workmanship, to support the weight of the heater and any other loads such as
snow.
c) Connect heater to the main gas line. An approved 1/2" flexible connector (available as an
option from the manufacturer) must be used to absorb gas line expansion and any vibration -
check local code requirements.
(d) Check gas line for leakage by using soap test or gas meter test. Ensure gas pressure meets
the requirements out lined in Section 2.4 (above).
WARNING:
When testing the main gas line pressure up to 0.5 psig, ensure that the isolation
valve and combination gas valve are "OFF", otherwise damage to the combina-
tion gas valve will result. When testing gas line in excess of 0.5 psig the appli-
ance and shut off valve must be disconnected from the gas supply piping system
during any such pressure testing.
Proper manifold pressure will be maintained when the main burner is operating under the fol-
lowing supply pressure:
LINE PRESSURE w.c.”
MANIFOLD PRESSURE w.c.”
MINIMUM
MAXIMUM
AT GAS VALVE TEST POINT
NATURAL GAS
6.0
14.0
5.0
PROPANE GAS
11.0
14.0
10.0
Natural Gas: models are orificed for 1000 BTU/CU.FT.
Propane Gas: models are orificed for 2500 BTU/CU.FT.
3. INSTALLATION PROCEDURES
Page 2
Содержание 2300 series
Страница 11: ...GP M230 BX 010A 2300 IO 210 Manual RD June 2006 R L 10A KH Diagram 4 2300 MOUNTING ARM TEMPLATE Page 7...
Страница 12: ...GP M230 BX 010A 2300 IO 210 Manual RD June 2006 R L 10A KH Diagram 5 2300 WALL BRACKET TEMPLATE Page 8...
Страница 14: ...GP M230 BX 010A 2300 IO 210 Manual RD June 2006 R L 10A KH Page 10 Diagram 7 SERVICING HEATER...
Страница 28: ...GP M230 BX 010A 2300 IO 210 Manual RD June 2006 R L 10A KH...