PASIAN Perla, Руководство пользователя

Страница: 23 / 56

MANUALE UTENTE
,
USO E MANUTENZIONE
M odulation
The stove is equipped with a water temperature probe that allows you to modulate its
power according to the desired temperature value.
To set the water temperature, press key “1”. By pressing key "1" once, it compares the
wording "SET WATER TEMP" in the lower part of the display, while in the upper part of
the display it compares the value of the water temperature set. To modify this value,
use keys “1” and “2” until the desired temperature is reached
START
After the preparation phase, the message “LOAD ” appears on the display and the
ignition phase begins. This second phase is divided into two parts: the preload and the
actual ignition.
At the beginning, the auger is activated and the fuel begins to fall into the brazier ..
As soon as the fuel covers the spark plug hole, you will first notice a redness in the
burner and then the ignition of the flame (FIRE PRESENT), the pellet supply is
reduced and the ventilation increased in a way.
To allow a stabilization of the flame and the disposal of the excess fuel accumulated in
the brazier during the ignition phase. This phase lasts about 5 minutes. At the end of
the stabilization phase ("FIRE PRESENT") the stove passes to the normal working
phase.
WORK
As soon as the ignition phase is finished, the stove goes into normal working mode,
during this phase it will be possible to change the power and temperature from the
display. Set the stove power by choosing from one of the 5 available levels. The power
is set by means of the KEYS “5” and “6”.
• Set the chronothermostat parameters (see the corresponding section below).
• Set the desired room temperature key "1" to increase and "2" to decrease
During the work phase, periodic cleaning of the burner is also active. The brazier
cleaning mode is activated for about one minute at regular intervals. In this mode, the
fume extractor works at maximum power while the pellet feed is reduced to a minimum.
This operation is necessary in order to eliminate ash deposits inside the brazier and
thus ensure proper combustion. During the brazier cleaning phase, the message
appears on the display.
The stove is equipped with an internal temperature probe that allows it to modulate its
power according to the desired room temperature.
For correct operation of the ambient probe, check that the thermostat probe positioned
at the rear of the stove is far from the flue pipe, and is not in contact with objects or
walls.