PASIAN Perla, Руководство пользователя

Страница: 15 / 56

MANUALE UTENTE
,
USO E MANUTENZIONE
3.4
WATER CONNECTION AND INDICATIVE ASSEMBLY DIAGRAMS
The "PASIAN IDRO" production allows, thanks to suitably indicated exchangers, to
transfer the heat produced by combustion to the water, which
heated, it is brought, through the plumbing system, to the radiators or sanitary
fixtures .If the thermo stove connection involves interaction with another pre-existing
system complete with another heating appliance (gas boiler, methane boiler, oil boiler,
etc ...), it is more recommended to contact qualified personnel who can then be
responsible for the compliance of the plant, in accordance with the provisions of the law
in force on the matter.
The company declines all responsibility in case of damage to things or people or in
case of failure or incorrect operation in the event that the above warnings are not
respected.
For the connection, it is advisable to arrange interception shutters in order to isolate the
machine from the water system if it is necessary to move it or move it to perform
ordinary and / or extraordinary maintenance or the replacement of mechanical parts.
When the appliance operates at full capacity it produces hot water at a temperature that
is necessarily lower than the boiling point, it is therefore necessary that the heating
system is designed compatibly with the characteristics of the machine. During
installation and during operation, keep in mind that the disposal of the minimum power
supplied by the device must be guaranteed (especially in multi-zone systems).
Make sure that the thermal plumbing system is equipped with an additional and
adequate closed expansion tank suitably sized, where necessary.
For the installation of an additional expansion tank, keep in mind that usually 1 liter of
tank compensates for 10 liters of the system and at least 1 liter is always dedicated to
the water inside the thermo stove. The expansion vessel inserted inside the appliance
is preloaded at the pressure indicated on the plate, adjust the pre-charge pressure of
the expansion vessels to the operating pressure of the heating system.
System filling
Before making the plumbing connections, carefully wash the heating system (pipes,
heating elements, etc.) with special pickling agents or descalers capable of removing
any residues that could compromise the proper functioning of the stove. The plumbing
connections must be made in a rational way using the stove connections of suitable
diameters.
The stove safety valve drain must be connected to a drain funnel. Otherwise, if the
drain valve intervenes and floods the room, the manufacturer of the stove will not be
responsible.