Parweld DP323C, Руководство пользователя

Страница: 8 / 30

www.parweld.com
1. Graphic display: The 5,7’’ colour screen displays
different screens, according to the welding mode or
settings. In weld mode the display is divided into five
principal:
Part 1: Machine status
Part 2: Meaning of the active buttons (buttons 2, 3, 4,
5,6 di fig.1)
Part 3: Size values set
Part 4: Type of process selected
Part 5: Indicates the values that can be set for the
various welding settings (to change the values select
using switch 10 and confirm the selection by pressing
the same switch; the value will be highlighted in a
contrasting colour. The values can be changed by
turning the switch, to confirm the new value press the
switch again. 10).
Highlighted value: Indicates the parameter that is being
changed using switch 10.
DISPLAYS: - When the screen comes on, the Parweld
logo will appear and the Firmware revisions will load.
CONTROL BUTTONS: (2, 3, 4, 5,6 in fig.1)
Each control button is associated with a specific
function shown on the display.
7. SD slot: this slot, covered with a rubber cap,
contains the SD-Card provided with the machine;
without the card, the machine will be inactive and a
warning message will appear on the screen.
8. USB port: for technical assistance only. 9. Switch for
adjusting the principal welding settings: This switch is
used to set the principal welding parameters: MMA/TIG
Welding; set the welding current
11. H²O in: to be used only with liquid cooling torches.
12. H²O out: to be used only with liquid cooling
torches.
13. Connector for remote control.
14. “+” dinse front connector: positive pole inlet. MMA
Mode: Electrode holder
15. EUROCONNECTOR (SEPARATED TROLLEY):
quick connector for welding torch. This connector is
used to supply welding gas to the torch, the electrical
contacts of the torch button and the welding current.
16. ON-OFF switch: turns the machine on and off.
17. “-” dinse front connector: negative pole inlet.
MMA Mode: Ground clamp
TIG Mode: TIG torch
MIG Mode with gas: Not used
MIG without gas mode: Not used
18. “+” dinse front connector: positive pole inlet.
MMA Mode: Electrode holder
MIG Mode: Ground clamp
MIG with gas mode: Not used
MIG without gas mode: Not used
19. TIG gas Outlet
20.Connector for supplying power to the
liquid cooling system (Optional): Warning
the connector contains dangerous
voltages: NEVER use it for purposes other than
those for which it was specifically designed
22. WIRE SPOOL SUPPORT
The 300mm MIG welding spool requires an
external support
23. WIRE FEEDER SYSTEM: see figure 3A
for a more detailed image.
24. WIRE TENSION REGULATOR: Adjusts
the tension of the welding wire.
25. INLET OF THE WIRE FEEDER MOTOR
26. WIREFEEDER SPOOLS
7