Partlow MIC 1400, Руководство оператора

Страница: 27 / 71

MIC 1400 Manual Edition 1 27
DISPLAY AVAILABLE FACTORY
STEP DESCRIPTION CODE SETTINGS SETTING
8 Com Address CAd 1 - 32 1
9 CJC Enable CJC EnAb EnAb
diSA
* The Hardware Definition Code and input jumper configuration may need
to be changed. See Appendix B and C.
TABLE 3-3 TUNE MODE
To enter the Tune mode, press and release the SCROLL key until tunE is
displayed. Use the DOWN key to enter the Tune mode. Depress and
release the SCROLL key to sequence through the parameters and their
values, alternately showing the parameter code in the lower display with the
upper display blank, then the parameter code with the parameter value
displayed. Use the UP and DOWN keys to adjust the parameter values.
After adjusting a parameter, depress the SCROLL key to proceed to the
next parameter. Use the DOWN key to advance to the next parameter
when a parameter code is showing in the lower display and the upper dis-
play is blank.
To exit the Tune mode, press the UP key whenever a parameter code is
displayed in the lower display and the upper display is blank.
1 Ramping SPrP
±
Setpoint Limits Read Only
Setpoint Value
2 Setpoint Ramp SPrr 1 to 9999 units/hour OFF
Rate and OFF
3 Input Filter Filt 0.0 to 100.0 2.0
seconds in .5 sec.
increments
4 Input Correct iCor
±
Span 0
5 Output 1% Po1 0 to 100% Read Only
(Continued on next page)