Particle Measuring Systems HandiLaz, Руководство оператора

Страница: 31 / 48

HandiLaz Operator’s Manual Page 5-1
Chapter 5
Using Optional Accessories
External Printer Option
The HandiLaz may be used with the external thermal printer, to obtain hard
copy results of measurements. The printer may be powered in either of the two
following ways:
• wall current using the printer external supply (PMS parts PS139, PS140,
PS141)
•
the printer battery pack (PMS part EL193).
The printer is connected to the comms port of the HandiLaz by means of the
printer cable (PMS part CD33).
Paper for the external printer can be ordered from Particle Measuring Systems
(PMS part PR20).
Setting the DIP Switches on the HandiLaz External
Printer
Three sets of DIP switches, each containing eight switches (24 total) which
identify the communication, language, and print layout parameters that the
printer will use. A minimum of four switches must be changed for this printer
to be used with the HandiLaz. The switches which must be changed are labeled
by “*” below. After completing the following procedure, the HandiLaz will
print successfully.
To prepare HandiLaz for printing:
1 Turn the printer off.
2 While holding the “On-Line” button, turn the printer on.
3 The printer will print the current switch settings, followed by:
4
Push the “On-Line” switch.
“Continue?: Push ‘On-Line SW’”
“Write?: Push ‘Paper feed SW’”