Great Pyrenees Installation Instructions
Page 6 of 8
Mounting the Antenna
Step 1.
Feed the coaxial cables from the antenna through the hole in the bracket.
Step 2.
Remove the backing from the adhesive pad on the underside of the antenna and place the antenna on the
bracket. Apply downward pressure on the antenna to ensure strong adhesion.
Step 3.
Guide the flat washer, star washer (optional), and hex nut onto the cables. Thread the washer(s) and nut
onto the antenna shaft and fully tighten using a 2.25” wrench until the antenna is pulled flat onto the
bracket. (Figures 6 & 7)
Figure 6
Figure 7
Routing the Cables
Step 1.
Route the cables from the antenna to the router, maintaining a minimum bend radius of 0.5”. Avoid sharp
bends and run the cables adjacent to existing wiring.
Step 2.
Waterproof the RF connectors using electrical tape or heat shrink tubing, if required.
Installing Multiple Antennas on a Pole
When installing multiple antennas on a single pole, ensure that the antennas are mounted at least 24”
apart on the pole.