16
At its first use, the unit will release a smell caused by the paint and the burning of oily substances used in its
manufacture. It may activate the smoke detectors. Open windows to vent.
NOTE:
Since the glass door is cold when the unit is turned on, condensation may temporary settle on the glass.
1.
Whatever the fuel used, it is recommended to start the unit with wood pellets. This will quickly raise the vent
temperatures for a better and faster start up. Failure to use wood pellets could result in slow and difficult lighting
procedures. Before each startup, make sure the burn pot and the ash pan are completely empty.
Caution:
Never attempt to start a fire if the burner is hot and completely full of ashes.
2.
After filling the hopper, press the hand icon (11) to activate the manual feed (primer). All doors must be closed.
The manual feed procedure will be in operation for approximately 90 seconds to fill the feed system and few pel
-
lets will drop into the burner.
3.
How to start the unit:
Open the main door, fill the cup with wood pellets and drop the pellets into the burner.
Sprinkle generously the pellets in the burner with an approved fire starter gel and mix well with the poker tool.
Next, use a
match
to light the fire starter in the burner and close the main door. Press the start icon (7, 8, or 9) of
your choice. A1 will be displayed for a total of 4 minutes and the combustion fan will start.
Some fire starter gels have a low alcohol content which will result in a weak start-up
Procedures steps for startup
WARNING: DO NOT START THE UNIT IF THE GLASS DOOR IS CRACKED OR
BROKEN AND NEVER CLEAN THE GLASS WHEN IT IS STILL HOT.
WARNING FOR EMPTY HOPPER:
Starting the unit without first activating the manual feed
(primer) can generate smoke in the unit.
First start up
Lighting on your unit
WARNING: Never use the manual feed procedure to start your unit.
Caution: May cause smoke issues in the combustion chamber.
Image 2
