Parkside PMSG 200 A1, Инструкции по эксплуатации и безопасности

Страница: 77 / 118

76 GB/MT
To fix it in place, rotate in a clockwise
direction. If you are in any doubt,
then please contact a professional.
„
Connect the cable assembly with
direct connection
10
to the appropri-
ate connector. To fix the connection,
tighten the fixing ring
38
in a clock-
wise direction.
„
Then connect the earth cable
4
with
the corresponding connector, marked
with the “+” and to fix the connec-
tion in place rotate in a clockwise
direction.
z
Insert welding wire
„ Note:
Please unlock and open the
cover of the wire feed unit
1
, by
pushing the release knob upwards.
„
Unlock the roller unit by turning the
roller mount
27
anti-clockwise (see
Fig. F).
„
Pull the roller mount
27
off the shaft
(see Fig. F).
Note:
Make sure that the end of the
wire does not come loose and cause the
roll to roll out on its own. The end of the
wire may not be released until during
assembly.
„
Completely unpack the welding
wire reel
15
, so that it can unrolled
without difficulty. Do not release the
wire end yet.
„
Place the wire reel on the shaft.
Make sure that the roll unwinds on
the side of the
29
wire feed guide
(see Fig. G and M).
„
Place the roll mount
27
back on and
lock it by pressing and turning it
clockwise (see Fig. G).
„
Undo the adjustment screw
25
and
swing it downwards (see Fig. H).
„
Turn the thrust roller unit
26
to the
side (see Fig. I).
„
Loosen the feed roll holder
28
by
turning it anti-clockwise and pull it
forwards and off (see Fig. J).
„
On the top of the feed roll
18
, check
whether the appropriate wire thick-
ness is indicated. If necessary, the
feed roll
18
has to be turned over or
replaced (see Fig. E). The supplied
welding wire (Ø 1.0 mm) must be
used in the feed roll
18
with the spec-
ified wire thickness of Ø 1.0 mm.
The welding wire must be positioned
in the upper groove!
„
Erect the feed roll holder
28
again
and screw clockwise direction.
„
Remove the torch nozzle
7
by
pulling and turning it clockwise
(see Fig. K).
„
Unscrew the welding nozzle
14
(see Fig. K).
„
Guide the cable assembly with direct
connection
10
away from the weld-
ing device as straight as possible
(place it on the floor).
„
Take the wire end out of the edge of
the spool (see Fig L).
„
Trim the wire end with wire scissors
or a diagonal cutter in order to
remove the damaged, bent ends of
the wire (see Fig. L).
Note:
The welding wire must be
kept under tension the entire time in
order to avoid a releasing and a roll
out! Therefore it is recommended to
carry out the work with an additional
person.
„
Push the welding wire through the
wire feed guide
29
(see Fig. M).
„
Guide the welding wire along the
feed roll
18
and push it into the cable
assembly holder
30
(see Fig. N).
„
Swivel the thrust roller unit
26
towards the feed roll
18
(see Fig. O).
„
Mount the adjustment
25
screw
(see Fig. O).
„
Set the counter pressure with the
adjustment screw
25
. The welding
MIG welding