Parkside PFDS 33 A1, Оригинальное руководство пользователя

Страница: 12 / 37

PFDS 33 A1
■ 8
│ GB │ IE │ NI
Unpacking and checking the package
contents
1.) Remove all components from the packaging and check whether the
flux-core welder or the individual components show any signs of
damage. If this is the case, do not use the flux-core welder. Contact the
manufacturer via the service address provided on the warranty card.
2.) Remove all protective films and other transport packaging.
3.) Check that the delivery is complete.
Assembly
Fitting the welding mask
♦ Fold the side parts of the mask inwards.
Press the integrated clips into the corresponding holes so that they click
into each other (see fig. D).
♦ Lay the dark welding lens into the mask with the writing at the
top (see fig. E).
The writing on the dark welding lens must now be visible from the
front side of the welding mask.
♦ Push the handle from the inside into the corresponding recess on
mask, until it clicks into place (see fig. F).
Filling with flux-cored wire
WARNING!
► To avoid the danger of electric shock, injury or damage:
– Before maintenance or pre-work preparation activity,
always disconnect the mains plug from the mains
power socket.
NOTE
► Depending on the application, different types of flux-core wires will
be required. This appliance can use wires with a diameter from
0.7–1.0 mm.
► The feed roller, torch nozzle and wire diameter must always match.
► The appliance is designed for wire rolls of up to a maximum of 450 kg.
♦ Open the cover of the wire feed unit by turning the catch (see
arrow marking) to the position UNLOCK (see fig. 1).
Fig. 1
♦ Unlock the roller unit by turning the roller mount
A
90° anticlockwise
(see fig. 2).
♦ Pull the roller unit from the shaft (see fig. 2).
Fig. 2
NOTE
► Make sure that the end of the wire does not come loose and cause
the roll to roll out on its own. The end of the wire may not be
released until during assembly.