Parkside PFDS 33 A1, Оригинальное руководство пользователя

Страница: 13 / 37

GB │ IE │ NI │
9 ■
PFDS 33 A1
♦ Unpack the wire roll completely so that it can be unrolled unimpeded.
Do not release the wire end yet (see fig. 3).
♦ Place the wire roll onto the shaft. Make sure that the roll unwinds on
the same side as the wire feed guide
C (see fig. 3).
♦ Put the roll mount A back on and lock it by pressing and turning it
clockwise 90° (see fig. 3).
Fig. 3
♦ Undo the adjustment screw D and swing it upwards (see fig. 4).
Fig. 4
♦ Push the press roller unit E to the side (see fig. 5).
Fig. 5
♦ Undo the feed roll holder F by turning it anticlockwise and pulling it
upwards and off (see fig. 6).
♦ Check the upper side of the feed roll
G
to see if it is the correct wire
size. If required, the feed roll must be turned over or exchanged. The
supplied welding wire (Ø 0.9 mm) must be used in the feed roll G
with the next biggest specified wire thicknesses of Ø 1.0 mm.
The wire must be positioned in the upper groove!
♦ Replace the feed roll holder F and screw it tight.
Fig. 6
♦ Remove the torch nozzle by turning it to the right (see fig. 7).
♦ Unscrew the flow nozzle (see fig. 7).
♦ Route the cable assembly away from the welder as straight as
possible (laying on the floor).
Fig. 7
♦ Pull the wire end from the edge of the spool (see fig. 8).
♦ Trim the wire end with a wire cutter or a diagonal cutter to remove any
damaged/bent wire (see see fig. 8).
NOTE
♦ THE WIRE MUST BE HOLD ON TENSION ALL THE TIME, TO AVOID
A RELEASING AND ROLL OUT! We recommend that you always
carry out work with the help of a second person.
Fig. 8