Parkside 310843, Перевод оригинальной инструкции

Страница: 31 / 118

PTS 710 A1 ■ 28 │
GB
│
IE
Inserting/replacing the battery
■ Open the battery compartment cover with a
matching slotted screwdriver.
■ If necessary, remove the used battery.
■ Insert a new 3 V button cell (type CR 2023) in
accordance with the polarity shown. Screw the
lid of the battery compartment cover back
on.
CAUTION!
If operating and adjustment equipment is used
or procedures other than those specified here
are carried out, this may result in hazardous
radiation exposure.
Setting up
NOTE
► The appliance is equipped with a Power on/
control lamp . This lights up green as soon
as the appliance is connected to the mains.
This indicates that the appliance is live.
Check base plate/blade guard:
WARNING! RISK OF INJURY! Always
remove the plug from the mains pow-
er socket before carrying out any
work on the appliance.
♦ Check the freedom of movement of the base
plate before each use .
♦ Activate the safety lock-out and keep it in
that position. Lower the circular saw. In this way,
you can test the function of the base plate . It
must move freely. It may not jam.
♦ After letting go, it must be move smoothly back
to its starting position of its own accord.
Switching on and off
Switching on:
♦ Activate the safety lock-out and keep it in
that position.
♦ Press the ON/OFF switch . Once the saw is
running, you can release the safety lock-out .
Switching off:
♦ Release the ON/OFF switch .
Selecting the cutting depth
NOTE
► We generally recommend setting the cutting
depth to approx. 2 mm more than the thickness
of the material. This ensures that you achieve
a clean cut.
♦ Let go of the quick-release lever of the cutting
depth preselector . Set the desired cutting
depth on the scale . Clamp the quick-release
lever tight again.
Fitting the rip fence
♦ Loosen the screw for the rip fence on the
base plate . Insert the rip fence into the
rip fence slot . Retighten the screw for the rip
fence .
Handling the circular saw
1. Place the machine on the material. If necessary,
align the machine with the rip fence or on a
marked line.
2. Switch on as described in the section "Switching
on and off".
3. Press the appliance forward to lower the circular
saw.
4. Saw by applying moderate pressure.