Parkside 273098, Руководство по эксплуатации и технике безопасности

Страница: 17 / 64

12 GB/IE
14. Troubleshooting
Fault Possible cause Remedy
Motor does not work Motor, cable or plug defective, fuses burnt Arrange for inspection of the machine by a
specialist. Never repair the motor yourself. Danger!
Check fuses and replace as necessary
The motor starts up
slowly and does not
reach operating speed. Voltage too low, coils damaged, capacitor
burnt Contact the utility provider to check the voltage.
Arrange for inspection of the motor by a specialist.
Arrange for replacement of the capacitor by a
specialist
Motor makes excessive
noise Coils damaged, motor defective Arrange for inspection of the motor by a specialist
The motor does not
reach its full power. Circuits in the network are overloaded (lamps,
other motors, etc.) Do not use any other equipment or motors on the
same circuit
Motor overheats easily.
2YHUORDGLQJRIWKHPRWRULQVXI¿FLHQWFRROLQJ
of the motor
Avoid overloading the motor while cutting, remove
dust from the motor in order to ensure optimal
cooling of the motor
Reduced cutting power
when sawing Saw blade too small (ground too much) Readjust end stop of the saw unit
Saw cut is rough or
wavy Saw blade dull, tooth shape not appropriate for
the material thickness Resharpen saw blade and/or use suitable saw blade
Workpiece pulls away
and/or splinters Excessive cutting pressure and/or saw blade
not suitable for use Insert suitable saw blade