Parking Facilities PF9500A, Руководство по эксплуатации и обслуживанию

Страница: 31 / 40

Troubleshooting Guide (electrical)
PF9500A
ELECTRICAL ERRORS CAUSE CORRECTION
Blank screen on Panel but power to other devices
in the control panel
Door switch circuit not making Press door switch in and check Panel screen
Panel has developed an electrical fault or had a
power spike or blown on board fuses
Change fuses or panel MAKE SURE that the
panel is run through a MCB 14 amp breaker
Gate does not run (stays open)
Check panel is showing no F Codes or E codes Power down then back up press and hold “stop”
key to reset
Loop detector is faulting or sensing presence Clear obstacle or reset the detector
Check panel settings have not been altered Set P.990=1 then P.991=0101
Gate staying up in open position Access control giving a constant pulse shorten
this
Photo cell batteries (if fitted)
Check that the fitted batteries still have power to
them. They should only be replaced with special
3.6V Lithium-ion batteries made for purpose. These
can be provided by your supplier
Photo cells dirty (if fitted)
Clean photo cells make sure they are debris free
Mains on but no power Isolator fuse Check and meter fuse in isolator
Gate not going up Access control may be faulty Remove and check Gate function via the Panel
buttons
Gate Staying up Car has driven off before clearing the loop panel
is configured without “no passage” timer.
Complete cycle by going through the ground loop
“
e.211
” displaying on screen
Gate door is open Close door or check switch for faults
Gate staying open and not closing
If photo-cells fitted then batteries may have
expired
Check and if needed replace batteries
Faulty loop detector Check & set or replace faulty unit
Gate does not have loops fitted or these have
been removed
Call the technical department for assistance the
program/wiring needs to change
Key switch left in open position Put the switch back into the “Auto” position
Permanent supply/signal to the open terminals Check wiring to terminal blocks remove any
access control try again
Gate programmed for safety only or Gate is on a
timer
Contact your supplier for a program modifacation
chip
15