Parking Facilities PF9500A, Руководство по эксплуатации и обслуживанию

Страница: 7 / 40

Manual Release Guide
PF9500A
6
Gate Maintenance
PF9500A
Please use the following instructions to operate the Gate manually, the following
is assuming you have powered down the unit and opened the cabinet door:
As stated at the beginning of this manual we recommend a bi-annual service, but at a bare minimum, it is imperative
that you get a service done once every 12 months. This is not a sales tactic in disguise, there is a very serious
health and safety issue/risk associated with not complying to this. Also in order for your Gate to keep complying with
the appropriate legislation.
Before carrying out any maintenance to the installation, disconnect the mains power supply.
Make sure you have disconnected/Isolated the power before attempting any work.
A Maintenance Contract should be sought from a specialist company after a maximum of 5000 manoeuvres or 1year from
the install date.
Occasionally clean the photocell optical components and make sure they are free from dirt, water, rain, soil etc..  Batteries
in photo cells may need to be changed every 6 months or sooner dependant on use. Gate will not work properly without
photo cell function.
Have a qualified technician (installer) check the correct setting of the electric clutch.
If the power supply cable is damaged, it must be replaced by the manufacturer or its technical assistance service, or else by
a suitably qualified person, in order to prevent any risk.
When any operational malfunction is found, and not resolved, disconnect the mains power supply and request the
assistance of a qualified technician (installer). When automation is out of order, activate the manual release to allow the
opening and closing operations to be carried out manually.
Gearbox drive unit is “sealed” for life and requires no further lubrication.
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
3.
4.
1.
2.
10 mins
60 5
10
15
20
25
30
35
40
45
50
55
Remove the dust cover plug
then get the brake release key
from its holder in the cabinet
and insert it into the top of the
motor.
Now the Key is inserted fully
i n t o t h e t o p h o l e t u r n
clockwise to open and anti-
clockwise to close. After this
you must remove the brake
key and replace the bung.
FAILURE TO DO THIS WILL
A L L O W D A M A G E T
VERY
IMPORTANT!!!!!!
H E
BRAKE/MOTOR AND THE
GEARBOX.
!!!!!! THIS IS
!
Remove the release key
from holder on the door
then insert the release
key in the exposed hole.
Keep pushing with a
downwards pressure and
turn clockwise to screw
into the hole which will
release the brake. Do
this until you feel it is
hand tight.